0001 <?xml version="1.0" ?>
0002 <endurox>
0003 <appconfig>
0004 <!-- ALL BELLOW ONES USES <sanity> periodical timer -->
0005 <!-- Sanity check time, sec -->
0006 <sanity>1</sanity>
0007 <!-- If process have been state changed to other than dead, exit or not running
0008 but PID of program does not exists in system, then send internel message, then
0009 program have been stopped.
0010 In Seconds.
0011 -->
0012 <checkpm>5</checkpm>
0013 <!-- <sanity> timer, end -->
0014 <!-- Do process reset after 1 sec -->
0015 <restart_min>1</restart_min>
0016 <!-- If restart fails, then boot after +5 sec of previous wait time -->
0017 <restart_step>10</restart_step>
0018 <!-- If still not started, then max boot time is a 30 sec. -->
0019 <restart_max>30</restart_max>
0020 <!-- <sanity> timer, end -->
0021
0022 <!-- Time after attach when program will start do sanity & respawn checks,
0023 starts counting after configuration load -->
0024 <restart_to_check>20</restart_to_check>
0025 <!-- Send full service table every 5 seconds -->
0026 <brrefresh>5</brrefresh>
0027 </appconfig>
0028 <defaults>
0029 <min>1</min>
0030 <max>1</max>
0031 <autokill>1</autokill>
0032 <!-- Do not need respawning! -->
0033 <respawn>1</respawn>
0034 <!-- The maximum time while process can hang in 'starting' state i.e.
0035 have not completed initialisation, sec -->
0036 <start_max>20</start_max>
0037 <!--
0038 Ping server in every X sanity units
0039 -->
0040 <pingtime>9</pingtime>
0041 <!--
0042 Max number of sanity units in which server must respond.
0043 The granularity is sanity time.
0044 -->
0045 <ping_max>40</ping_max>
0046 <!--
0047 Max time to wait until process should exit on shutdown
0048 -->
0049 <end_max>30</end_max>
0050 <!-- Interval, in seconds, by which signal sequence -2, -15, -9, -9.... will be sent
0051 to process until it have been terminated. -->
0052 <killtime>20</killtime>
0053 </defaults>
0054 <servers>
0055
0056 <server name="atmi.sv58">
0057 <min>2</min>
0058 <max>2</max>
0059 <srvid>10</srvid>
0060 <rqaddr>ADDR1</rqaddr>
0061 <sysopt>-e ${TESTDIR}/atmisv-dom1-ADDR1.log -r</sysopt>
0062 </server>
0063
0064 <server name="atmi.sv58">
0065 <min>2</min>
0066 <max>2</max>
0067 <srvid>100</srvid>
0068 <rqaddr>ADDR2</rqaddr>
0069 <sysopt>-e ${TESTDIR}/atmisv-dom1-ADDR2.log -r</sysopt>
0070 </server>
0071
0072 </servers>
0073 </endurox>
0074
